Skip to content
ZJBESS
Illustrative residential setting with a five-module ZJBESS rack battery cabinet and wall-mounted solar inverter

5kWh 48V Server Rack Battery

For home solar and backup.

Key product details

The ZJBESS JJ5KW is a server rack battery: a 51.2V 100Ah LiFePO4 module for 19-inch battery racks. Each 4U module stores 5.12kWh and runs a 500W load for about 8.5 hours; two to four modules build a 10–20kWh home or telecom bank. Built and tested in our factory in Shandong, China.

  • 5.12kWh · 51.2V 100Ah · 4U, 19-inch rack format
  • 18 inverter protocols, selected on the 3.5-inch touch screen
  • 8,000+ cycles at 25°C, 0.5C, 100% DOD · 10-year warranty
  • Up to 15 modules in parallel for 76.8kWh · JJ10KW / JJ20KW options
JJ5KW at a glance

A 48V server rack battery your installers already know how to fit

The JJ5KW is the rack-mounted 5kWh module in the ZJBESS home battery range. Grade A 3.2V LiFePO4 cells in a 16-series, 51.2V 100Ah pack are steel-banded inside a 442mm-wide, 178mm-high steel chassis: the 4U, 19-inch format used by telecom and solar battery racks. A smart BMS with a 3.5-inch touch screen, Bluetooth and Wi-Fi sits on the front panel with the terminals and breaker.

It is a battery-only product. Pair it with any 48V hybrid or off-grid inverter that uses one of the 18 built-in battery protocols, or with a ZJBESS inverter. For more energy per module see the JJ10KW and JJ20KW; for a single cabinet, the 15kWh floor-standing LS15KW.

  • Build 5, 10, 15 or 20kWh banks from one SKU
  • Fit existing 19-inch battery and telecom racks
  • Add modules later as the customer's load grows
  • Stock small, light cartons: 45kg per module
5.12kWhPer module
51.2V48V system
100AhGrade A LFP cells
4U19-inch rack
3.5-inchTouch screen
15 modules76.8kWh in parallel
8,000+Cycles at 25°C
10 yearsWarranty
Capacity in practice

What can a 5kWh rack battery power?

About 4.2kWh reaches the AC loads from one full JJ5KW module. Most homes use two to four modules; the table shows one module and a four-module, 20kWh bank.

Average AC loadTypical loadsRuntime, 1 moduleRuntime, 4 modules
300WLED lights, router, phone charging14.1 h57 h
500W+ fridge, TV, ceiling fans8.5 h34 h
1,000W+ laptop, freezer, water pump cycling4.2 h17.0 h
2,000W+ 1.5HP inverter air conditioner2.1 h8.5 h
3,000WWhole-home daytime use1.4 h5.7 h

How many solar panels charge a 5kWh battery? About 1.3kW of PV, or 3 × 550W panels, refills one JJ5KW in a day with 5 peak sun hours (5.12kWh ÷ 5h ÷ 0.8 system factor = 1.28kW). Add the panels needed for daytime loads on top.

Installation

Rack-mounted: slide in, link, grow

The JJ5KW goes where rack batteries already live: telecom shelters, plant rooms and home battery cabinets. One installer can handle a 45kg module.

Slide into the rack

The 442mm chassis fits 19-inch rails and takes 4U of height. Check rail depth for the 452mm body plus rear cable space.

Link the modules

Parallel power and communication cables connect the modules on the front panel. Addressing is set before the modules leave the factory.

Grow the bank

Start with two modules and add more on the same 51.2V bus, up to 15. Every module carries its own screen and BMS.

Smart BMS

Tap. See. Control. A BMS your installers can read on site

CAN or RS485 to the inverter, Bluetooth and Wi-Fi to the ZJBESS app, and a 3.5-inch touch screen where the installer picks the inverter protocol.

Protocol Direct Select

Pick the inverter brand on the module screen before the modules are linked; no laptop needed.

A screen per module

Each module shows its own SOC and alarms, so a fault in a five-module rack is found at a glance.

Cell-level alarms

Voltage and temperature of the 16 series cells in every module, balanced from 52.8V.

Remote service

Bluetooth on site, Wi-Fi from your office: read the whole rack without opening it.

Eight protections, set at the factory

Overcharge

Charging stops at 58.4V

Over-discharge

Recommended cut-off 44.8V, BMS cut-off 40V

Overcurrent

JJ5KW held within 100A continuous

Short circuit

Instant disconnect on a terminal fault

Low-temperature charge

Charging blocked below 0°C

High temperature

Charge and discharge stop above 60°C

Overload

About 5.5kW peak per JJ5KW

Cell imbalance

Balancing and alarm per cell

Performance

Key performance advantages of the JJ5KW

8,000+
cycles

Rated at 25°C, 0.5C and 100% DOD with more than 80% capacity left. One full cycle a day is more than 21 years of cycling, so the 10-year warranty, not cell wear, sets the planning life.

4U
19-inch module

442mm wide, 178mm high. The industry rack format, so distributors sell it into racks customers already own.

76.8
kWh in parallel

Up to 15 modules on one 51.2V bus. Energy adds up module by module, voltage stays the same.

≤50mΩ
internal resistance

Measured at 50% SOC. Low resistance means less heat in a closed rack and a flatter voltage under load.

Visual reconstruction of the ZJBESS 51.2V LiFePO4 datasheet cycle-life chart at 25 degrees Celsius and 0.5C for three depths of discharge

What 8,000+ cycles mean for your customer

At one full cycle a day, 8,000 cycles is more than 21 years of cycling, against 500 to 1,500 cycles for lead-acid at 50% DOD. The 10-year warranty, not cell wear, sets the planning life, and shallower daily cycles extend it further.

Inside the battery

Steel-banded cells in a 4U steel module

Inside each module the cells are compressed and strapped with steel bands, the module process used in EV power batteries.

  • Steel-banded Grade A cells. New, QR-scanned, matched cells held at constant pressure, which slows capacity fade.
  • Shock and vibration. The pack stays rigid through sea freight and handling in and out of racks.
  • Front-panel service. Screen, breaker, terminals and ports are on the front, so modules are checked without pulling them out.
Blue prismatic battery cells arranged on trays in the factory
Steel-banded LiFePO4 cells, interconnects and wiring in an open battery
Inverter compatibility

Which inverters work with the JJ5KW?

Protocols for 18 inverter brands are built in, so the inverter charges by the JJ5KW BMS limits, not a fixed voltage.

Pylontech protocolGrowattVoltronic (Axpert)LuxpowerWOWSchneiderDeyeVictronSorotecSMAGoodWeStuderMUSTGinlong (Solis)SenergyTBBMegarevoAiswei

Two modules suit a 3–5kW inverter; four modules run the ZJBESS 6kW ED off-grid inverter at full output with current to spare.

Select the protocol

Choose the inverter brand on the module screen before linking the bank.

Connect CAN or RS485

Link the modules, then connect the bank communication port to the inverter over CAN or RS485.

Set lithium mode

Set the inverter battery type to lithium / BMS communication.

Check the readings

Check that the inverter sees the bank total: modules × 100Ah.

Pre-loaded for your market. Tell us the inverters you sell and our BMS engineers set the protocol before the JJ5KW is crated. For a brand outside the list, send the model and firmware and we build the match.

Battery packs and electrical test equipment on the ZJBESS workshop floor
Applications

Where the JJ5KW is used

Home solar racks

Two to four JJ5KW in a small rack beside the inverter give 10–20kWh of evening and backup storage, with room in the rack to add more.

Telecom and network cabinets

The 4U, 19-inch format drops into telecom shelters and network cabinets for 48V DC backup, set to a 57.6V charge voltage on the rectifier.

Off-grid cabins and kiosks

Start with one or two modules and add more as the solar array and the load grow. At 45kg a module, one person can carry the next one in.

Scalability

One module from 5kWh to 77kWh

Up to 15 JJ5KW modules run in parallel on one 51.2V bus. Distributors stock one rack module and quote every bank size from it.

UnitsNominal energyAt the AC loadsTypical system
15.12kWh4.2kWhBackup for lights and router
210.24kWh8.5kWhSmall home, 3–5kW inverter
420.48kWh17kWhHome with a 5–8kW inverter
630.72kWh25.4kWhLarge home or shop
1051.2kWh42.4kWhMulti-rack site
1576.8kWh63.6kWhMaximum parallel bank
Know before you buy

JJ5KW limits your installers should know

5.12kWh is nominal

About 4.2kWh reaches the AC loads per module after the discharge window and inverter losses.

Rack sold separately

The JJ5KW is the module. Tell us if you need a rack, rails or cabinet and we quote them as a separate line.

Rail depth and load

Each module is 452mm deep and 45kg. Check rail depth, rear cable clearance and the rack's load rating.

Same model in parallel

Expand only with JJ5KW modules. Mixing JJ5KW with JJ10KW, or other brands, in one bank is not supported.

100A per module

Each JJ5KW is rated 100A continuous, about 4kW. For a 5kW inverter we quote at least two modules, for 8kW four.

Rack room above 0°C

Modules discharge to −30°C but will not charge below 0°C. Keep the rack in a heated or insulated room.

Ventilate the rack

Closed cabinets warm up under load. Leave gaps between modules and air flow through the cabinet.

Get a Wholesale Quote

Tell us your required battery capacity, application and inverter model. We will confirm the suitable configuration before quotation.

ZJBESS Project Enquiry
Get a Wholesale Quote

Tell us your required battery capacity, application and inverter model. We will confirm the suitable configuration before quotation.

ZJBESS Project Enquiry